Cavo di programmazione per controller EBS programmabili

This cable connects your PC to a programmable controller. This way you can adjust a lot of settings to customize the controller to your very personal requirements. only recommended for very experienced users.

Suited controllers:

• EB206
• EB209
• EB212
  

All conversion kits from July 2012 and later are delivered with EB3xx series controllers. Please use the appropriate cable only.

Important note:

Cable and software are not manufactured by us. This product is subject the following limitations:

• We do not provide any support for installing the software
• We do not provide any support for software operation
• We do not provide any support for controller configuration
• We disclaim any liability for damages caused by using the cable or software.
  

Please be advised that incorrect programming can damage the controller. Removing the seal from the controller voids warranty.

Information about installation and operation of software can be found in this English-language forum: Endless Sphere. the forum "Endless Sphere" is not run by Ebike Solutions.

Programming software, driver for the cable and a standard file can be downloaded at the bottom of this page. We do not assume any liability for any damages caused by using any of these files.

You can also have EBS controllers custom programmed for you without loss of warranty.

go to controller configuration